Coatings // Licensed crews

Roof Coating Los Angeles:
tested before we seal

Every coating we put on a Los Angeles roof starts with a test. The roof is opened in one small spot before anything else happens, and what comes out shows whether a coat can work. When the layers are dry, we seal the roof you have under one continuous coat, every lap closed and the afternoon sun turned back, with nothing torn off. When they are wet, you hear that first.

We core the roof first

Coatings matched to each roof

License CSLB #1100046

Test cut // Coat or replace

What a cut through the roof tells us before we coat

A coating renews the surface of a roof, but it cannot reach the layers below it. So the first job is a cut: a plug comes out and each layer is read in turn, from the membrane through the insulation to the deck. That settles roof coating vs replacement faster than any opinion, because wet layers stay wet under a fresh coat.

Roof coating Los Angeles: a core sample lifted from an aged flat roof

Coat // Dry layers

The core comes up dry

Every layer the plug brings up is dry to the touch. The structure is sound, so all the coat has to do is renew a worn surface.

Re-cover // Worn sheet

Bare felt across the field

A membrane cracked open across most of its field leaves a coat nothing to hold. A new membrane is the better call here, laid over this one or after a tear-off, depending on what the core shows.

Coat // Surface wear

Only the top layer is worn out

Everything wrong here is skin deep: a cap sheet crazed by sun, a few lifted laps, a flashing coming loose at the parapet. Those get fixed by hand, and then a single unbroken coat goes down over all of it.

Replace // Wet core

Soaked insulation, a soft deck

If water runs out of the core, or the deck sags when someone stands on it, the roof is wet inside. Trapping that moisture under a coat helps nobody, so the honest call is a roof replacement in Los Angeles rather than a coat.

Coat // Local wet spots

Only a few patches are wet

Two or three soft spots do not condemn a roof: they are cut out and rebuilt dry, and the coat then runs over old and new as one surface.

Repair // Pitched roof

Steep tile or shingle roofs

A coating has to lie on a continuous membrane, and overlapping shingles or clay tile are not one. On a pitched roof we repair the broken pieces or replace the covering, and we say so on the first call.

Silicone roof coating // Los Angeles

Silicone vs acrylic roof coating: choosing by how the roof behaves

The right coating depends less on the brand than on how the roof behaves: whether it holds water after rain, bakes in full sun all afternoon or takes regular foot traffic. Gravel-surfaced built-up roofs and modified bitumen qualify too, once the loose stone and granules come off and what remains passes the same core test.

Silicone roof coating Los Angeles: rolled white over a weathered flat roof

Standing water

Silicone roof coating

Where puddles linger a day or two after a storm, silicone keeps holding and shrugs off UV, which makes it the usual choice for flat roofs with stubborn low spots. Little bonds to cured silicone except more silicone, so every later recoat is silicone.

Full sun, clean drainage

Acrylic roof coating

Acrylic is water based and goes on bright white, which makes it a strong elastomeric roof coating for a roof that sheds water cleanly and sees little foot traffic. Water left standing on it for days slowly softens it.

Foot traffic, rooftop units

Polyurethane coating

Of the three, polyurethane takes knocks and boot traffic best. On commercial roof coating work where technicians service rooftop units often, it guards the walk paths and the ground around the equipment.

TPO, PVC, EPDM

Primers for single-ply

Single-ply sheets are slick by design, so a coat laid straight onto them can peel. A primer chosen for that sheet goes down first, and the silicone or acrylic finish then has something to grip.

Six steps // Prep to proof

Six steps behind our roof coating services

The top coat is the easy day. Washing, drying, repairs and seam work take most of the time on the roof and decide how long the coating lasts. They are also the first things a rushed job skips, and a commercial roof coating project runs through the same six steps as a house.

Elastomeric roof coating base coat brushed into a lapped flat roof seam

Step 01

Washdown and full dry-out

The field is washed under pressure until the chalk, grime and loose granules are gone, then left until it is bone dry: a coat over a damp surface is a classic reason coatings let go.

Step 02

Fix what the core found

Every wet area the core revealed is opened and rebuilt with dry material. Active leaks get a proper roof leak repair at the source, and blisters and lifted edges are cut out and sealed flat.

Step 03

Seams, flashings, penetrations

Water finds the joints before it finds the field, so every lap, curb, wall flashing, pipe and vent is sealed first and then built up with a second pass of base coat.

Step 04

Primer, where the surface asks

Slick single-ply sheets and chalky, weathered surfaces get the primer the coating maker specifies for them before any base coat goes on.

Step 05

Base coat, then top coat

Rollers or spray rigs lay each coat in overlapping passes until it reaches the thickness printed on the product sheet. Nothing new goes on until the coat beneath it has cured.

Step 06

Water test and handover

The cured roof is soaked with a hose while someone watches every seam and drain. The job closes with the photographs, the product data and the written warranty.

Sun // Standing water

Does roof coating reduce heat? On a dark flat roof, it does

Heat is the first test, and a white roof coating is built for it. Summer in Los Angeles pushes a dark membrane far past the air temperature, which ages the roof and warms the rooms beneath it. Standing water is the second test, and its fix starts with the drainage, not the coat.

Cool roof coating in bright white across a wide flat roof in Los Angeles

Cool roof Los Angeles: when the rules apply

Sunlight that bounces off a white surface never heats the roof: the whole idea of a cool roof coating under the Los Angeles sun. Title 24, the state energy code, covers many low-slope roofs in California when re-roofed, so rated products matter on commercial roof coating work. For houses, the City of Los Angeles adds a cool roof rule when over half of a roof is replaced, repairs aside. Cool roofing over a bare deck is roof installation work.

Standing water needs a way off the roof

Water that is still standing on a flat roof two days after rain is ponding, a drainage fault long before it is a coating question. We get the scupper working, build slope into the low area with tapered insulation and only then coat, the same order our flat roofing crews follow. A sagging deck is a structural problem first, and no coat, however thick, can ever fill a dip in the structure. Silicone is the coat of choice where some water will always linger.

Homes // Flat sections

Residential roof coating: Los Angeles homes with a flat roof

Plenty of houses here pair a pitched roof up front with a low-slope roof out back, over a converted garage or a rear addition. That low section is where many homes leak first and where summer heat pours into the rooms below. The pitched part keeps its tile or shingle and gets ordinary roof repair when it needs it.

Garages and additions

Flat roofs over rooms you use

A bedroom or office under a flat roof takes the full afternoon sun. A white coat over that section turns much of the heat away, which is where residential roof coating changes the most indoors.

Older low-slope roofs

Extra years before a re-roof

If the core comes up dry, a coat keeps an older low-slope roof in service for years longer and pushes the tear-off further out. You keep the roof that works and renew only its surface.

Mixed roofs

Only the flat part is coated

On a house with both kinds of roof, the coating stops at the flat section. The flashing where it meets the slope is rebuilt first, because that joint is where water so often gets in.

The paperwork

Photos and papers you keep

When the house is sold or the roof is due for a recoat, those records tell the buyer or the next roofer which product is up there and how thick it went on, so the right coating goes over it next.

Shared buildings // Roof restoration Los Angeles

Commercial roof coating for apartments, HOAs and businesses

Apartment buildings and storefronts get the same chemistry a house gets. What changes is the planning: residents, owners and staff stay inside, so commercial roof coating can be scheduled in phases around them, one roof section or one building at a time.

Flat roof coating half applied on an apartment building roof
Commercial roof coating sprayed white over a warehouse membrane roof

Apartments, condos, HOAs

Residents can stay at home

Boards and managers can see the plan before work starts: which roof, which week and where the crew goes up, details a property manager can put straight into a resident notice. A large complex can be phased so that only one building at a time has work over it.

Retail, office, industrial

Business can carry on below

The crew can work above an open store or a running warehouse floor, one section at a time. A roof that fails the core test goes to our commercial roofing team for a re-roof.

Thickness // Warranty

How long does roof coating last, and what keeps it going

A coating lasts about as long as its thickness and the prep beneath it allow, and warranties show it: one major silicone system earns a longer term with a heavier application. Timing is the other half. Owners who plan the next recoat before the top coat wears thin keep the same roof in service instead of tearing it off.

Silicone

How long does silicone roof coating last?

Silicone resists UV and standing water, so on a well-prepared roof that got its full specified thickness, the manufacturer’s warranty term is a fair guide to its working life.

Acrylic

What wears an acrylic coat down faster?

Ponding and grit. Water that sits on acrylic for days softens it, and dirt left on a white acrylic surface dulls the reflectance it was chosen for, so a regular rinse is part of keeping it.

Recoat

Can roof recoating replace a tear-off?

Before the top coat wears through, the roof is cleaned and coated again with the same chemistry. Roof recoating renews the surface without touching the insulation or the deck, so the original roof works another cycle.

Warranty

Is the roof coating warranty in writing?

Its term depends on the system and the thickness applied, and it is written into the warranty itself, not promised on the roof. On a building with a manager, that file passes to the next one.

Before you hire // Four checks

Roof coating contractor, Los Angeles: four checks before you hire

A search for roof coating near me tends to bring up directories and lead lists before any contractor. Whichever contractor you end up calling, four checks separate a roof coating company that tests and documents its work from one that sprays and leaves.

License

A license you can look up

Ask for the license number and check it on the Contractors State License Board website before anyone climbs a ladder. Ours is CSLB #1100046, and any contractor should hand over theirs just as quickly.

Core sample

Proof of what is underneath

A contractor who coats without cutting into the roof is guessing. Ask to see the core, or a photograph of it, before you sign anything.

Product and thickness

The system named in writing

Ask which product goes on, how many coats and the thickness its maker requires for the warranty term you want. A vague line that only says white coating leaves room for a thin job.

Proof at the end

Photos, data, water test

Before and after photographs, the product data, a water test across the finished field and a written warranty are what a finished coating job should end with. A contractor who offers none of them is not the one to hire.

Questions // Short answers

Roof coating Los Angeles: the questions owners ask most

Ten questions owners ask about coating a flat roof, each with the short answer first.

Is roof coating worth it on an old roof?

It is when the core comes up dry: a coating renews a sound low-slope roof and keeps it in service for years without a tear-off. Over wet insulation or a soft deck it cannot fix the real problem, and we say so first.

Does roof coating stop leaks?

Partly. A coat seals surface wear such as open laps and cracked membrane once they are repaired. Water coming in at a wall, a skylight or from wet layers inside the roof needs its own repair, so every leak is traced first.

Who does roof coating near me?

In Los Angeles, our own licensed crews do, under CSLB #1100046. Call 747-298-6407 any day from 7 AM until 10 PM. The first visit is a roof walk, with a core where the surface hides too much.

Do you take on commercial roof coating?

Yes. Commercial roof coating on apartment buildings, HOA properties, shops and warehouses gets the same core test and the same paperwork a house gets. Owners often call it roof restoration, since the old roof stays in place under a new surface.

Should my roof get silicone or acrylic?

Silicone where water lingers after rain, acrylic where the roof drains well and sits in full sun. Silicone shrugs off ponding and UV, but later coats must be silicone too. Acrylic is bright and easy to recoat, yet standing water softens it.

Will a coating cool the rooms below it?

On a dark roof, yes. A lot of the heat in a top-floor room comes down through the roof, and a white coat stops much of it at the surface, most of all where a flat roof sits over living space.

Can a coating go over shingles or tile?

No. A coat needs one continuous surface to seal, and overlapping shingles or clay tile never give it one. Those roofs get a repair or a new covering instead.

Do you coat flat roofs on houses?

Yes. Flat roof coating covers the low sections of a house, over a garage, a rear addition or a patio, and the pitched part is left alone unless it needs its own repair.

Is a roof coating warranty included?

Yes, in writing, handed over when the job is done. How long it runs depends on the coating system and how thick it went on.

What does a roof coating company check?

A careful roof coating company checks the layers with a core, the drainage, every seam and flashing, and the surface type that decides the primer. Those checks are what keep a coating from peeling within a few seasons.

Roof walk // Next step

Book the roof walk, get a straight answer

A short call is enough to start: tell us the roofing material, about when it went on and where puddles form after a storm. One of our roofers then walks the roof, takes a core where needed and comes back with photographs and a clear recommendation: coat, repair or replace. Our phone, 747-298-6407, is answered every day from 7 AM to 10 PM, and the form takes requests at any hour, for a house or a commercial roof coating job. You deal with one licensed Los Angeles roofing company from the first call to the water test.

Service area

Los Angeles and surrounding areas

License

CSLB #1100046, bonded and insured

Hours

7 AM until 10 PM

Roof walk // Online